|
|
|
The RB-6
Pneumatic Clip Gun installs RB Clips quickly and perfectly. For above
floor or under floor applications in radiant floor heating, or in potable
water pipe installations, the clip gun shoots safe, strong polyethylene
clips that fit perfectly without compressing or damaging the tubing or
pipe
|
 |
|
The "hammer head" of the
pneumatic tool repeatedly strikes the two nails of the RB Clip until they
are driven 5/8" into the wood. The RB-6 Pneumatic Clip Gun is designed to
install clips perfectly, with no chance of overdriving the nails or
piercing the tubing. The installation will be fast, strong, and
long-lasting, providing holding power that absolutely cannot pierce or
damage the tubing or pipe. |
|
Unlike other pneumatic
tools, the RB-6 is lightweight and easy to use. This makes it especially
comfortable to use overhead, such as in "staple up" radiant heating
installations. Also, a quick connect fitting is included with the gun and
an air plug is preattached, making set-up easier. |
|
Installed
tubing and clip |
After
attaching the air hose, load in a strip of clips and align the tool over
the tubing so that it rests directly onto the wooden surface. Smoothly and
completely depress the handle allowing the head of the tool to repeatedly
strike the nails until the clip is fully seated. The RB-6 Pneumatic Clip
Gun will not permit the nails to be overdriven. |
| |
|
|
